I modified the top and bottom sphere to allow a greater tolerance to
hopefully avoid some people needing to sand the parts.
This is my second model from the TV series Timeless. This is the "companion" to the Mothership the Life Boat
There are only 6 unique pieces but most of them will need to be printed multiple times.
The Filename of each states how many times you should print.
Support me on Patreon
I printed mine mostly at .1mm so that I can retain as much detail as possible.
I printed the outer rings at .5mm since they were small and I wanted to keep every little detail.
After it was printed I did do a wash with black acrylic paint to make sure all the details were highlighted.
If you don't know what a wash is, its when you water down acrylic paint and brush it all over your object and then lightly wipe it away so most of the paint is taken away but it stays in the cracks and divets.