This project is an enclosure for a D1 mini 8266 wifi board
and a XBS SD card spi board. This project is a portable web
site and wifi access point that can serve files stored on the SD card.
Music, pictures, documents or a few videos can be shared with
everyone at the local coffee shop.
Printed with 200C extruder and 70C bed temp. Print tends to curl (lift) slightly on the corners. You can print with a brim or raft if needed. The design is a little complicated in that there are several pockets for the 2 PCB's to sit in that require cutouts and clearances for the solder and pins that extend beyond the bottom of the boards. Three holes exist in the enclosure for the external wifi antenna, the micro usb (power) connector and the slot for the SD card. The software was developed using the Arduino IDE with the 8266 extensions.