Tired of carrying around an extra tool head when vacuuming? Need both the carpet head and the tight corner nozzle? Don't want to stick that dirty tool in your pocket? Forgot where you put it down?
This should help.
It clips directly onto the Dyson V8 stick and features the same tool receptacle as my earlier project, https://www.thingiverse.com/thing:2427172.
The idea is that when you are vacuuming you need to carry at least 2 tool heads. E.g. the carpet and the thin nozzle for the corners. This tool carrier will allow you to clip the one to the end of the vacuum for use, and the other on to the stick so that it is always near at hand. The only time you will need to remove it is if you want to go under low furniture item, like a bed.
I have included both the STL (if you want to slice it yourself) and the gcode I used (if you trust my slice). I think the way I printed it gives it the most strength, esp. where it clips on the the Dyson.
Happy printing folks!
Small little support to break out of the clip receptacle. Just beware not to stab yourself!