A remix of the BLTouch mount for JGAurora A5 with fixed height.
I use this mount with a 3DTouch from Aliexpress:http://s.click.aliexpress.com/e/b8D6OHm0
I made it because I couldn't fit the BlowHard 3000 fan duct with the original mount.
This mount also have the advantage of not having to setup the 3DTouch position on the mount each time this one is taken down.
Installation instruction are available here: https://jgaurorawiki.com/a5/modifications/bltouch
Replace the original screws with M2x6mm, because the original screws are to short.
Here are my offset settings (but you should still measure your own):
#define X_PROBE_OFFSET_FROM_EXTRUDER 12
#define Y_PROBE_OFFSET_FROM_EXTRUDER 38
#define Z_PROBE_OFFSET_FROM_EXTRUDER -2,35