Thanks to all the likes and positive feedback I got on my first 3D printable quad frame!
This new version is partly based on all the suggestions I got from the community.
- Closed top plate to make fixing the VTX easier
- Closed bottom plate with slot for FrSky R-XSR
- New 45° SMA antenna mount
- Thicker 4.5mm Arms
- More space for the ESC/FC stack
After playing around with a few materials this latest version is made out of cured PLA.
You simply leave the print on the heat bed at 100°C for 30-45min at put an old filament box over it to create a little oven. The curing releases tensions in the material and changes the microstructure to make it much more resilient.
You will need some regular 20mm standoffs: https://www.banggood.com/custlink/G3GmYngZuU
If you like my FPV designs check out my carbon frames too:
You can find my recommended setup for beginners below. The performance you can get nowadays for small money is absolutely astonishing.