This system consists of 3 pieces.
1x ceiling mounted badge holder
1x badge 6900-2RS-EZO bearing cable slide guide
1X wall mounted double 608z bearing cable slide guide
Its simple and effective. This allows your headset cable to reset above your head when you bend down and pick stuff up. I have a counter weight on the end of cable under the wall mounted guide. When bend all the way over the spring clip is engaged and the cable will lower. If you hit the maximum travel distance the cable will then begin to roll through the bearing and wall mount with the extra cable by the counter weight.
note: For the wallmount I did not print it at the right density so the insert peg was weak. I drilled out a 4mm hole and am using an M4 button head screw to hold the bearings together tightly.
The retractable badge holder I am using is very strong and very cheap: