Replacement wheel for the Igea Compact vacuum cleaner. Slightly modified in some parts for strength and easy printing.
Any PETG, ABS, PLA
Place with outer side down, it needs support there, but that surface is later covered by the original cover and invisible. Print a bit hotter than usual for greater strength.
Remove supports and clean up the print.
Now you have to disassemble the old wheel: Using a thin screwdriver, lever the outer cover off the original wheel. Then pull off the rubber part. Do this by levering a small part out of the groove that you can then grab and pull the entire thing off.
Now to assemple the new wheel: Place the rubber part on the printed wheel and insert the flanges in the grooves. Now just snap the cover in the three holes. Congratulations, you have a new wheel!
Insert the wheel axle in the hole and screw on the holder disc using a 3,2mm wood screw. Repair finished!