Duet wifi 2020/3030 case
What is it?
A case to fit to a Duet wifi to an 2020/3030 extrusion with a 40mm fan. It is designed to be mounted vertically with the fan on the bottom and exausting on the side so no debris can fall in. It has an airflow guide underneath to cool the drivers and vents which are probably enough to cool the bed mosfet, I use an external mosfet so I can't be certain on this.
There are three screw holes on the side which will make it sit flush to a 2020/3030 extrusion with the cables leaving the side, make sure you print the version for your extrusion type.
What do you need?
- 3 M5x8mm screws with T-slot nuts to mount in to and extrusion.
- 4 M3x20mm screws with nyloc nuts to mount the fan.
- 3 M3x20mm screws with nyloc nuts to mount the board
- 1 M3x10mm screw that taps into the fourt hole next to the air duct and mounts the board.
If your printer can do small/medium length bridges you should be fine.