This is a BLtouch mount for the folgertech FT-6 printer. This mount uses M3 Square nuts and M3X10mm screws to affix the holder to the gantry. Height of the bltouch is adjustable.
UPDATE 31 JAN 2019
Users in the folgertech facebook group were asking for a center hole to allow access to the offset adjustment screw. I have uploaded a version with this modification.
Now includes firmware. The firmware assumes the following:
Your using a reprap discount smart controller for the LCD
All axis is using A4988 drivers
BL touch is installed to servo0 pins with the WHITE/BLACK wires connected to the Z-MIN endstop pins
If your setup is different than this, change the appropriate settings in config.h