X carriage for Prusa i3 to add Igus Drylin RJ4JP-01-08.
This is actually a remix of Original Prusa MK2s X carriage : https://www.prusa3d.com/prusa-i3-printable-parts/
I choose PET-G.
Note that the bearing fit quite tightly, if your material shrinkage is too high
Resolution recommended is either 0.2mm or 0.27mm, I printed at infill of 21%
Material should be PET-G ( mind the shrinkage which may take from 1-4% )
Due to the fact that the filament printed destroy the roundness of the perfect circles in any printed hole I personally recommend to print it on the side with supports to achieve roundness.