THIS IS A SOLUTION TO MOUNT THE E3D V6 WITH VOLCANO HOTEND WITH Z-PROBE
This Thing is a Work-In-Progress
But these files are a functional setup. I am using it continuously.
This Thing contains a spacer-mount for the heatsink, an adapter for the fan, a fanduct to volcano, an adapter for the probe. It was designed for the original effector(model uploaded - you don't need it).
I bought a clone of E3D V6 with contains a small fan(blue) which for the cooling of the heatsink. If you want to use auto-bed-leveling you have to remove and put on the adapter of the sensor.
You need 4M3 screw with nuts. The original screw at the fanduct can be resused.
To assemble the mount of the sensor you need 2M3 screw with nuts and the magnetic part ot the original effector.
There will be updates.
- The adaptor of the 5015 radial fan is not the best, in some cases can hit the rods.
- I will make a fanduct for to original V6 hotend too.
- Management of the cables required.
Smaller dimensional changes.
The fanduckt and the adaptor was designed for 0.4 nozzle with 2 perimeters.
The heatsink-mount need to be bridged because of the overhangs.
Removing support material
Do it carefully, some parts are weaker than you expected.
Bridges from the middle of the heatsink-mount must be removed.