Black and white
Print the lithos with 100% infill and 0.15mm layerhight.
If you print them laying flat on the bed turn off the layer fan if you have one.
Print all attached parts
Select some pictures you like with the right size (landscape from 1600x1200 pixels)
Go to http://3dp.rocks/lithophane/
For the settings see attached pictures!
I printed them laying flat on the bed with 0.15mm resolution, you can also try to print them standing up if you have good first layer adhesion.
IMPORTANT: If you print them laying flat don't use a layer cooling fan!
If you use cura, try the feature adaptive layers! Works like a charm :)
If you have al parts (plus four lithos) test the led strip for function and go to step 4
Sand the LED path to get the best adhesion for the LED strip and clean it afterwards with isopropanol or something similar.
Apply superglue on the LED path and mount the LED strip
Cut the not used strip at the connection points
Slide the remote controller through the hole in the "Litho lamp" and push it into the place seen in the pictures above.
Connect the remote controller with the LED strip. If it is not tight enough use superglue on one side (make sure you got the the pins in the right place --> test the LED strip)
Put the cable protector in the hole and apply some superglue.
Put the heart in the lid and apply superglue.
Put on the lid, plug in the cable, pic a colour with the remote control and enjoy :)
Litho Image Settings
Litho Model Settings
Sand the LED path
Apply superglue to the LED path
Glue the cable protector
Apply superglue to the heart and the lid