This is a work in progress I'm designing the parts one by one and will add them as I print and test fit them, this doesn't mean that parts that i have uploaded are not going to change as i may discover down the road that something doesn't work the way i expected, that's all part of my design process (a mess).
once i have done designing and printing all the parts I'll add the final versions of them all and probably make a youtube video showing everything along with instructions on how to assemble everything until then this is very much just something to show where the project is going but I hope at the very least someone will find what I'm uploading to be inspirational or useful in some way. :)
Update 1 (11/01/2019)
I've been hard at work whenever i can trying to make progress on this and managed to get the covers for the power supply and controller housing finished as well as a few other parts like the plates that go in the sides of these, I decided to add a plate on the inside of the middle right section where the ventilation of for the power supply will be this is in case in the future i change my mind in any way about these parts and decide to maybe run cables this way.
I also discovered when i placed the parts i've already printed in the correct place they will be once everything is fully assembled that the cable for the display was a few inches short, to solve this for now i have unscrewed the box the controller is in and pulled the cable free since it goes all the way to the rear of the box before it leaves it, I'm considering solution to this is to redesign and replace this box, that would also eiiminate some other problems that may be about to come up such as ventilation for that controller and running other wires like the SD card and USB wire.
Anyways hope everyone has has a great new year so far and if anyone has any ideas please let me know in the comments of this project, would be amazing to get some input.