Watch Zeldathon Response this December 27, 2018 to January 2, 2019! All proceeds from this charity gaming marathon will benefit Direct Relief.
Here's a fun pair earrings, made especially for this event. (Spoiler alert: they're just my Master Sword Keychain with a french wire earring instead of a keychain attached.)
These are quick and inexpensive, making them good party favors and giveaways. I even sent 15 pairs along to Zeldathon!
If you enjoy this design, please make a donation to Zeldathon! Please mention where you came from in the comments. If you're not sure how much to give, I recommend $3.00 as a good starting point. (Or $3.14 if you're nerdy.)
Model: Mojo / Mojofibers
Start printing with black filament, with a first layer height of 0.3mm, then pause at the following heights for filament changes:
- 1.1mm Glow in the Dark
- 1.9mm Silver
- 2.3mm Blue
To simplify, skip 1.1mm change, or skip 1.9mm change and use Silver at 1.1mm.
You are granted a Creative Commons Attribution-Non-Commercial-ShareAlike License.
If you upload your design to Thingiverse, please use the "Remix" feature.
If you upload your design elsewhere, please link to this page or pikaworx.com.
I reserve the right to negotiate special licensing.