I wanted to install my Bigtreetech 8 diode TL-Smoothers inside the stock case of my TLM next to the MKS Sbase board. This allows for a perfect fit for X,Y&,Z smoothers in the left side of the case and it seems to offer plenty of cooling with the fan in the stock postion. I originally designed the slide-in smoother carriers in F360 and glued them to the original bracket. I found that it required a little extra clearance vertically from the fan inside the case, so I remixed the original bracket to allow for that clearance while integrating the carriers into the design. Print in the orientation shown in the screenshot in PETG, Nylon, ABS or ASA for heat resistance.
Should Print with any nozzle size between 0.40 - 0.60. Supports not required. Recommended 3 perimeters, 4-5 top & bottom layers. The photo shown was printed at 0.3mm layer height.
Use a drill bit or file to open holes for a snug fit to the brass nuts under the MKS board.
Remixed design with Fusion 360 based on the original file from Spirit00.