Here is our version of Frosty from classic Christmas cartoon Frosty the Snowman remixed for color printing. You can find the original on the left side of the screen.
We hope you're enjoying our designs, if so please check out our youtube channel @A Skewed View 3d & make sure you subscribe and ring that Bell as we have a lot of content coming out this year. We'd like to know what you think on our designs, please feel free to leave a comment on any of our videos and we will reply.
You can find our designs on thingiverse, & Myminifactory. You can follow us onTwitter now too @ A Skewed View 3d.
Remember if you need any 3d work done be it design, modeling or printing just contact us at firstname.lastname@example.org.
Thank you again for checking out our designs and have a wonderful day. God bless
I suggest printing the Model in parts to reduce the amount of waste and increase the number of possible colors. However you may print it all at once too. The print divisions I suggest are
- Lower Body - Support build plate only
- Head with eyes, nose, pipe - Support build plate only
- Hat with band, and flower - Support everywhere but change the threshold to only support the flower
- Broom Top, handle top, Base, brush base, tie - Sweep facing down with supports
- Broom Bottom - ~3mm Brim
With these configurations the waste towers will total ~51g (I used some large transitions, ~300 for black to white and some other colors)
If you print all at once the waste tower will be ~172g - over 3 times the waste, about 3 times the overall print time, and fewer colors.
The colors I used were: Inland for white and dandelion, AIO Robotics for the grey, pink,
and blue, Hatchbox for the black, Fiberology Vertigo for the eyes, Amz3d for the red, SnoLabs for the brown, and MadMaker Filaments for the tan.