I was printing some Zelda coasters as a gift for a friend and thought it would be cool to have a holder for them that was also Zelda themed.
I used Tinkercad to change the bottom of the coaster holder by jhdyuck to the
Zelda Coaster - Hylian Shield from my mini facotry and then added a triforce to both sides of the holder.
This holder can fit 6 100mm diameter by 5mm thick coasters.
I used hatchbox pla for the black and prusament silver for the hylian shield and did a manual color switch for the top layer of the shield.
I used 2 different coaster designs so I printed 3 of the "TriForce Coasters" by BillyJo182 I just switched filament first for the top layer of the triforce and then again for the final layer so the triforce stands out against the black background. The gold filament is hatchbox
For the second set of 3 I used the "Hylian Shield" coaster from my mini factory and just switched filament for the top layer.
The only changes I had to make to these designs was just resize them in my slicer so they were 100mm x 100mm x 5mm.