The cord-wrap bracket on my miter saw broke and there is no replacement available so I designed and printed one.
This is my first attempt at Fusion 360 and printing. It fits and it solved the problem so I call that a success!
If you print-one, please post a make so I can see if anyone else is benefiting.
I re-did the front-mount as well so I have a matched set. The front-bracket is a bit different the way it fits (arched and slightly shallower).
Both brackets are designed to use the existing screws to hold them and on my saw fit perfectly.
No supports required if you print it top-down. There is a .4mm layer at the bottom of the countersink you need to drill-out - that avoids having to use supports.
Infil is personal preference. I think this would be fine with less infil - but doesn't take that long to print.