- I added a new set of STL files that fit the new Moment Telephoto lens (it is bigger)
- The width is 4 mm wider than than v2 one.
- I removed the back two holes for the magnets ( not needed with the hinge )
- reduced the fillet around the top and bottom edge from 3mm to 2mm.
Moment makes lens for iPhones and Android phones. I have the Wide, Telephoto and Anamorphic lens with their lens brush also. I love their products.
I made a simple case to carry everything so that I don't have to worry about losing any of the pieces.
I tried to make the case as small and tight as I can without a lot of wasted space.
To attach the cover, just place both parts together standing up on its front. Then just "smack" the cover down into the base and viola, the top is now attached.
I put some holes in the cap and base to use small magnets to hold top shut. I put three in, but I only use the front one because that is all that is needed to hold it closed.
Be sure to flip the lens cap 180 degrees in your slicer so that the text is on the bottom. That way you don't need any supports.
7 bottom layers on the cap ( definitely overkill )
4 top layers
Gyroid fill pattern ( any pattern will do )
Extra perimeters if needed was checked
Seam position Rear ( make sure the hinge potion of the model is pointing towards the back )
Designed in OnShape