I sourced files from other users for hinges and edited the corner brackets I saw on other users to make an enclosure with 3 side panels and a door system on the front and not use any screws to hold the panels. It will require magnets - can be purchased from hardware stores and glued in place.
I used fastest standard settings on the SnapMaker and 2 Lack Table from Ikea to make this. If you want to add the vent for the laser, print the vent hole and cap. Cut a hole in the table (its made of veneer and cardboard, use a box knife to cut it) then glue the vent together in a corner of the table, then a zip tie to hold the vent flexible hose on it. (See Post Printing)
Print the Hinges with supports all around. The rest should not need support.
Adding the Fume Extractor
Underside of table with fan installed on back of table, and connected to vent hole.
Design of STL
I used TinkerCAD for creating the solids.