Back
Contents
Tags
Remixed From
Design Tools
A part of these Groups View All
License
Liked By View All
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.
Print Thing TagMakes
Summary
Now my Anycubic I3 Mega Hotend Cover (V1) was in use for almost a month.
However, it has been shown that the amount of cooling air was not quite sufficient, if overhangs were to be printed on small areas per level.
Then I designed the V2 - but the new fan didn't want to harmonize with the printer electronics.
Therefore now the V3, with which no fan, but a blower is used. This part blows enough air even if it runs at 50%.
Fans used:
- 1x Noctua NF-A4x10 FLX 40mm
- 1x Titan TFD-B7530M12C
BOM:
- 1x screw M4x40 + nut
- 4x M3x30 + nut
- 2x M3x16 + washer + nut
- 2x M3x16 + nut
- 2x M3x10 + nut
- 1x rubber band
Print Settings
Printer:
Velleman K8200
Rafts:
No
Supports:
No
Resolution:
0.25mm
Infill:
25% / 100%
Notes:
"Verbinder" and "LuefterTraeger1" @100% infill, otherwise 25% infill
All printed on the K8200 to avoid having to assemble/disassemble the I3 Mega over and over again.
More from 3D Printer Accessories
