The MAMBA is my own design.
The focus here was to design a slingshot that fits like a glove and requires little hand power to shoot it.
This is achieved in particular by the positioning of the index finger direction fork center.
As a result, the tensile stresses of the slingshot are effectively intercepted between the index and middle finger, and the fingers of the middle and ring finger. The little finger stabilizes with little effort.
In spite of a really loose grip, there is no danger that the slingshot will fall out of the hand when shooting.
The distance of the two fork ends is 50mm.
In the pictures, I have also included a scan of my hand to help to adjust the scaling of your own print.
Who likes it....I would be happy about a few cents as a tip ;-)
And please, please post your prints here. I would be happy!
Don't forget to check my other designs!
Good and cheap PLA
5 lines for wall
25 solid top and bottom layer
You will need support to print the slots!
It is recommended to sand the sling after printing (down to 1000 grit). ABS would be steamed on acetone.