this is a nice house by a lake with a dock.
it was exported from minecraft with the program mineways: goo.gl/IH3aP
it was painted using Testors brand acrylic paints. they are good paints but the cap always gets stuck.
it is 1.8"x1.3"; 0.8" heigh
or (in minecraft units):
(64x47, 28 heigh) blocks
@yupimcecil pictured, exercising his timeshare
printed on a makerbot replicator using the following settings:
raft + full support
layer height: 0.2mm
extra shells: 1
printhead speed: 35mm/s
printhead travel speed: 55mm/s
HBP temp: 119c