DISCLAIMER: I would not recommend printing this puzzle. At first it wouldn't turn, and it only became usable after a lot of sanding and break-in. Print at your own risk.
A deep cut, two-layered pentagonal prism twisty puzzle. The top and bottom layers can move in increments of 72 degrees, and each side can move 180 degrees. This puzzle cannot shapeshift.
To make this puzzle, print each part by the number indicated on the filename:
- 1 Alignment
- 1 Core
- 5 Inner Edge
- 5 Inner Corner
- 5 Hidden Corner
- 10 Outer Edge
- 10 Outer Corner
Although there are screw holes in the core, this puzzle does not require any screws to function. My puzzle worked fine with no screws, and all pieces are held together with tension.
Stickers can be cut from the attached template.
You should sand and spray paint the exposed faces, as it helps the stickers adhere.
The pieces should be printed with support. I would not recommend acetone welding Outer Corner or Outer Edge.
The core is placed under a lot of stress, so print the core with a high (>50%) infill.