This is a remix i made for the Tesla Model S
I split the model in two half so it is easier to print - Just glue the two parts together. No need for support now - Not even for the side mirrors :)
I also cleaned the model a little bit in Meshmixer
The wheels are the same as the original model - I printed 4 of these, facing with the rim up. I did use support for these.
I scaled the model a 1000% in Cura and i printed it with 2 walls, 2 bottom layers and 5 top layers. The print speed was 10 mm/s for the initial layers and 60 mm/s for the rest, the infill was printed with 200 mm/s
*I will soon update with pictures of the printed model!
3DE Premium PLA
Glueing it all together
After the two shells are done i used some super glue to glue them together.
I clamped them together using rubber bands
At the end, i used a quick grip vise to align the front and back of the car.
Over the night, i could remove the vise and rubber bands and glue in the tires