Original Description: Mount this in your kitchen to keep bananas fresh and out of the way. Folds up when not in use. Base requires supports when printing.
I ended up breaking two of the original bases (one at 20% and one at 100% infill) while removing the supports and testing their strength (relatively gently). They both broke at the same spot in the middle of the C part on the base.
- I've thickened the back area of the base where it was breaking and it's super strong at 50% infill. There are a few artifacts from using MeshMixer to reinforce the base, but it prints and looks fine.
I mounted mine with adhesive foam tape.
Thanks to heytiger for the awesome design.
20% for arm, 50% for base
- Supports Everywhere
- Default LulzBot HIPS Medium profile (240 tip/110 bed temps)
Meshmixer to add the reinforcement and NetFabb for final repair