-For thse with Winrar damage File error https://drive.google.com/open?
This is my profile settings for Sli3er Prusa Edition 2.1.0 and for older and newer versions
- I experimented with the Slic3rPE and was really happy with the results. I also Used Cura which is not bad but there are some problems I got with estimating printtime....Simplyfiy3d is in my opinion too expensive and not better than Cura ore Silic3erPE
- The Profiles are for Pla, but from Brand to Brand there are Chemical differences which can make a differenz in Quality and you may must change Temps And Speed. For other Materials visit https://www.simplify3d.com/support/materials-guide/ and for troubleshooting this https://www.simplify3d.com/support/print-quality-troubleshooting/
- This Profiles prints some layers like infill/travel at a high speed (max 200 mm/s).
- Infill example with all infill varaints on slicer which in the moment i go indeph but in the moment i woud suggest to use Gyroid.
- There are 2 Versions of Slic3er, the Original and the Prusa Version which is based on Slice3r
- My english is f****
- All steps Shown in Pictures
- Install the slicer Pruca Edition with the Custom settings option, dont use a standard setting, because they are for Prusa Printers and do not work well on you're Machine.
- Now load the Profile
- Change Profile Name because otherwise u cant safe changes.
- only for cr10 3d Mesh and Bedtexture
Auto leveling Version
- For CR10S-Pro There is no Autoleveling Start Gcode in the native versions but i have also a Auto leveling version with my Bltouch sensor u can use maby.
The Steppermotors sems to be the same as Cr10 so Acceleration and speed shoud match.
So when u give it a shoot leave a comment
- For_ CR10SPRO_CR10/S_Ender3_With_Autolevel
- V2 Better Supports removal
- V3 Overhauled
- V4 Jerk and acceleration reduced /Please use this version ore reduce the acceleration
- V5_alpha Start Gcode now makes a Big line to clean the nozzle. End Code retracts the Filament 5mm to decreas Filmament troping while nozzle is still Cooling.
-Marlin Firmware 1.1.9 for CR10 .
-V5 release versions with ajusted Buildsize for ender3, ender5 and cr10 iterations
My Printer Upgrades
- Marlin 1.1.9 Stock Creality Firmware has lack of features like 9 Point Bedleveling where u dont even ned flat printing surface ore auteleveling Probe.
- Direct Exdruder https://www.thingiverse.com/thing:3539760
- If you got some advise ore questions for my pleas don't hesitat and send my a PM ore make a Comment.
If you like my work a little Tipp is much appreciated
USE AT YOUR OWN RISK !!!
THIS IS NOT AN OFFICIAL PROFILE FROM PRUSA/CREALITY3D!!!