I liked the simplicity of
and the design of
but needed something a bit more sturdy to resist the utilization of the buttons on the back. The design should be printable without support and contain screw holes to mount it to my IKEA Ivar shelf.
v0.8 was a basic fitting test but the sunken screw holes had the wrong angle (120°) and were not deep enoug.
v0.9 is the design I am currently using but I disregarded an overhang so the inside looks a bit messy.
v1.0 is the final design and should be printable in a perfect condition.
The design should work with sunk screws up to 5mm. It features a tight fit so be aware you might get scratches on the silver frame of the status display when sliding in.
0.1mm but 0.2mm should be fine as well
Print with the arms upright to avoid overhangs (as seen on the screenshot). Possibly less infill is okay but I wanted solidity for the screw holes.