The CR-10 Cable Management System consists of three components, the strain relief bracket (with or without ABL mount), the Z-axis cable guide, and approximately 0.5m of 20mm plastic cable wrap, which can be bought for less than $10 http://a.co/d/6p47bxH.
This method of routing cables removes unnecessary load on the Bowden tube as in the CR-10's original configuration. The zip tie slots are optional, the 20mm cable wrap will snap into the guides at both ends. The strain relief bracket affixes to the X carriage with two M3x8mm screws.
The ABL mount uses the same offset as the EZABL and can be used with TH3D Unified Firmware without modification. For those using stock Marlin, the probe X offset is 48mm and Y offset is -2mm.
UPDATE: added a strain relief/cable guide for Petsfang
Strain relief bracket printed with 3 walls
It took a few iterations to get it right.