Star Wars Legion Hut
Standard bubble style hut in two parts, wall and roof.
Each part is 120mm diameter.
The roof has a flattened area on top of about 40mm diameter.
The figure shown is for scaling example only, and is not included.
Version 02 has 2.2mm bores for paperclip wire, and 3 parts.
This is in-case the wall misprints, you can redo parts as needed.
The lower wall can be scaled in the Z axis for different heights too.
Version 02 is compatible with version 01.
I printed it on 0.4mm resolution, 25% infill.
Rotate about 30 degrees so you get a good zigzag infill in the flat part of the wall.
Line Supports may be needed for the roof depending on your printer.