A truly evil design, displaying the beautiful skull of one of the most horrid demons who has ever roamed earth on the front. (His name may not be spoken) While on his sides you find two masterful crushed human skulls with the demon claws still grabing into the bone. To the back the spine spikes round it all up to a combined piece that will go around your finger or arm and never let go.
- Once the piece goes around your flesh your soul will be bound to hell for eternity.
- Once armageddon commences you won't be brutalized by the forces of hell and instead become part of their army, dental benefits included.
- If you intend to summon a demon this piece will may convince the demon not to eat you.
+8 Demon Summoning
The Demon Ring diameter size is 18mm, scale it accordingly to your finger size. If you know your ring size here is a international conversion chart: http://www.ringsizes.co/
It is quick print so you can always print another one. I recommend printing in the smallest layer height to get the most detail out of it, you might also want to print it slow.
The Demon Bracelet comes in a front piece and a back piece. The snap together as is but to hold it together on your arm you need print the addional Connector piece that goes through the hole in the pieces all the way around. It snaps and holds it tight together, see here: https://twitter.com/TocoGamescom/status/1034832810270515200
Instead you could also put a tight elastic band through the holes but it needs to be really strong and small enough.
If you like to spray paint the demon ring with a metallic spray can color I recommend putting the ring on rolled up A4 paper first. Then you can quickly turn it around while spraying and get on it from all angles. You have to be a little carefull to get not too much on it, better spray short and then wait a bit for another layer. If something goes wrong you can always print another one!
For the Bracelet you could put it on a cardboard roll with some tape in the inside and then spray from all angles. Then put it off and spray the inside.
I recommend printing in grey, dark or any color fitting to the spray paint since it can get hard to reach the cavities like the eye holes.