There are no additional parts needed for installation.
The part is constructed according to the height zero. See also the drawing.
On the back are omissions for the cover of the Hotend.
- No plug is needed to attach the cable to the mount. The cable can be soldered directly to the BLTouch.
My settings for Marlin
Settings in Configuration.h
#define X_PROBE_OFFSET_FROM_EXTRUDER -38 // X offset: -left +right [of the nozzle]
#define Y_PROBE_OFFSET_FROM_EXTRUDER -8 // Y offset: -front +behind [the nozzle]
#define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle]
Settings on the Printer Display after Testing:
Prepare → Bed Leveling → Probe Z Offset : -00.60
Please note that your settings may differ.
When setting up the Marlin firmware, an additional guide should be used, because some features are missing in this guide.
//G20/G21 Inch mode support
to avoid Errors with Serial-Printing-Software.