In addition to the original MEAN WELL SE-450 Mount, you will need the following:
- 4 x M3*10mm Hex Socket Cap Screws
- 4 x M3 Hex Nuts
You will also need to replace the two M4*8mm screws on the top of the power supply with longer screws to accommodate the base of the mount:
- 2 x M4*12mm Button Head Hex Socket Cap Screws
Before mounting the power module board, attach the headed bed and supply power leads to the board. Then slide the shield into place.
Attach the board to the mount with the four M3*10mm hex socket cap screws and hex nuts. Make sure the nuts seat evenly and are drawn up at least flush with the bottom of the mount. You may wish to use the screws without the board in place to pull the nuts into the recesses.
Finally, use the two M4*12mm hex socket cap screws to affix the mount to the top of the power supply and attach the control wire.