Bits holder for Ikea Skådis. The holder holds 91 bits (7 x 13).
The hooks are quite tight when fastened to Skådis.
The holder is at a 30 degree angle, and is intended to be printed face down. Some of the angles at the bottom of the hooks are steeper than 45 degrees and may need supports when printed.
I had some warping (as I often do, not sure if it's the Finder, FlashPrint or something else). Nothing serious though.
The holes are supposed to be a snug fit for the bits, and some holes were too tight, possibly because of warping during printing. To fix this I used a 7mm drill on all the holes (in reverse mode to avoid drilling all the way through).
I measured some drill bits as well as some existing holders with a caliper. Then I used Fusion 360 to design the model.