A voronoi design sculpted Xbox Controller holder/stand with wall mounting holes.
DONT PRINT IN INITIAL ORIENTATION.
Print this model in the orientation you would expect to have it stood at, the file is not in the right orientation when first loaded.
While this will print with no support or raft, it builds quite large from small bases. Once the different sections join together it become much more stable.
I use a large brim to help these stay in place until it's stable but it can be touch and go. Cutting off the object bottom by 1 or 1.5mm will help a lot to give a better first layer adhesion area and be more stable printing throughout.
None - Remove Brim
Remove the brim that helped it stick and its good to go. You could paint it if you wish but I think single colour looks good.