I wanted to replace the feet that came along with my Prusa i3 MK3, but most of the designs I found needed at least partial disassembly of the frame.
So, I decided to make one. There were a few simpler options available, but I thought of going a little extravagant and applying all the new stuff I had learned in Fusion 360. :P
- The main body was split into two so that it could be printed easily without supports. I printed them on my MK3 and the tolerance was enough for a good fit. Hopefully, it works for everyone.
- Once assembled (refer the attached figure), align the screw head parallel to the length of the body. Place it onto the frame, with the screw head going in through slot on the frame and just rotate the gear anti-clockwise.