This is a wall mount to hold filament spools for the XYZPrinting Da Vinci Mini and Jr models. This does not work well with 3D printed spool rings, as it is designed to work best with the included spool rings. I hope this works well for you!
•The wall mount now has an optional NFC Card Holder so you don't have to keep unscrewing your spools!
•This can be made on any printer, layer size does not matter very much, supports and rafting are unnecessary.
•Screw size is not final! Feel free to edit the hole size to whatever size you want. Please message me or comment with recommended screw sizes.
You can print on any 3D printer.
Take the main body and screw into the wall near your printer. Make sure the flat face is facing down. Screw size is NOT final. Current hole is about 4 mm. After screwing it in, hang your filament spool on it to make sure it works correctly. After leaving the spool on for a minute or two, take it back off. Finally, glue the end cap onto the end of the main body, hold it for the recommended time for your glue, and then put your filament back on.
Note: You may need something to hold the NFC chip to the sensor on your 3D printer for it to detect the filament correctly.