Updated 1/12/2019 - Additional changes to the brass pockets.
Updated 1/11/2019 - Added blank tray with no caliber markings.
Updated 6/25/2018 - Slight dimensional change to the pockets.
A 50 round reloading tray inspired by the ever popular Frankford Arsenal Perfect Fit reloading trays. The stackable design allows for convenient storage. This tray will also stack with the other reloading trays that I've designed!
9mm Luger, 9mm Parabellum, 9x19mm, and other cartridges that share similar case dimensions such as 380 Auto, 38 Super and 9x18 Makarov will all fit in this reloading tray.
Print with PLA or some other filament with high dimensional stability/low shrink factor, and a decently tuned printer is highly advised, as the tolerances are fairly tight.
Monoprice Maker Select v2.1
I used PLA to print this. The tolerances around the cases are pretty tight, so the use of a filament with high dimensional stability/low shrink factor is highly advised.
Recommended infill is 5% honeycomb pattern. Do not use less than 5% infill with the honeycomb pattern. A higher infill percentage can be used if desired, but print times will increase.