This is a large capacity pellet hopper that attaches to the Filabot EX2 to fit around 3Kg of pellets.
I printed mine in hatchbox orange PLA, then sanded the inside (my retraction was off so there was a ton of goobers on the inside surface).
Use 3M double sided tape cut to match the profile of the mount and stick on the EX2. The footprint clears the bolts and gives a really clean look when printed in orange.
I've included a lid to keep out dirt and debris.
This has been tested on an EX2, and feeds all pellets except 4 granules that hung up on the ledge.