I decided to post this version of the frame all by itself to make it easier to find. Same as the Micro64 but designed for the BeeCore Omnibus F3 V.1 flight controller or any other same size Whoop FC (FC spacing: 36X36MM diameter 3.0MM). USB cut out will need to be slightly adjusted depending on what FC you decide to use.
Designed to use the 0703 size motors with 40mm props.
Completely 3D printed all 910 Nylon filament except for the battery holder which was printed with TPU. All plastic screws minus the metal motor screws. 27g with the runCam nano, 3min flight time and 24g with the FX805 combo, 3.5 to 4min flight times.
Best filaments to use:
NylonX from Matterhackers.
Alloy 910 from Taulman3D.