*Updated file to be on the bed correctly. No longer standing on Z axis.
On a whim I decided to create a simple Tri-force Amiibo base. To liven it up a bit I added stencils of the "Zelda" (from the BOTW logo) and the "Z" from that logo (minus the flower) in the center piece.
I inset the center piece by 2mm to convey the missing piece. Originally I was going to place a different character in the middle but noticed that the Guardian worked really well.
I have some plans to potentially do one with a stencil of the Hyrule Crest instead of the Z but for now, here it is.
Tolerance is decent on this if you have an accurate printer. All amiibo go in and out nicely and don't slip out.

Prusa

i3 MK3

No

No

.20

20

*You will need a large build plate. I used a 200x 200 bed but lightly smaller will work.
I used a heated bed and Gold filament (Hatchbox) at 200 degrees fiirst layer and 197 degrees subsequent layers. This took about 10 hours. The infill is triangles (eh?) and I used 3 walls to attempt to mask any visibility of those walls from the outside.
The "Zelda" on the side could have been better and I might consider inlaying it more in the future.
Same goes for the "Z" in the center.