New Version available Here - https://www.thingiverse.com/thing:3343456
Designed a Vent Ring that also directs some of the wasted Wind from Hot-End's fan.
Wanted a full Circle that was Unique,
Forced air in certain areas for faster print speeds,
Would not send anything towards the Nozzle,
Redirected the Hot-End airflow that goes low.
This is the Surviving design.
You may need to Loosen the screws of your hot end fan housing to level this out.
many come from factory just slapped together and not adjusted. It's a $200 printer with
great parts. Please don't over-tighten this into your fan.
The original version that works best on early Ender-3's.
Short is for more clearance from bed
I have thinned the screw mounts on short 2 for the newer Ender-3's that have short screws
.stp file of Short Version has been included
For those who have tipped me a coffee, I offer back a huge thanks.
For those who wish to, I drink the cheap stuff.