I added a new model (front part) with a glass holder and some glasses as requested. Just glue the glasses to the model. No modifications to the back part. If you do not want to reprint the front part just glue the glasses to the model and cut out a little from the existing model. Have fun!
A huge beautiful looking case for you Raspberry Pi 3b+
To print this beast you need around 30-40 hours depending on your printer.
What you need to print:
What you need to assemble it:
3x bigger screws to screw together the back and front part
2x small screws for inside the case (hold raspberry pi in place)
and most importantly you need every cable (micro usb, hdmi, ethernet, usb) in low profile or you risk to not have enough space in the case!
How to assemble:
- Glue the three connectors in either the top or back part
- Mount Raspberry Pi and do your cable management
- Stick front and back together and use the 3 screws (cut the connector a little if needed)
- Done. Now look awesome :)
If anyone has a colored squirtle stl file please message me...
You only need supports with the back part. Infill 10% is more than enough. You need around 300-400m of pla