Castle tower for your succulent? Yes, another succulent planter for your desk or home. This one has a deep well feeder on the side that allows you to water from the side of the pot. The soil will wick up the water as needed to the roots of your plant. This also has a nice outer and inner tower staircase. This is the little brother to my other Tower Planter Pot found here: https://www.thingiverse.com/thing:2821572
This was printed using 3D Bizard 3D Tech Wood PLA at a resolution of 0.2 and 20% infill. There is no need to use supports when printing. All the over hangs are arched and should print just fine without support.
Bizard 3D Tech Wood PLA: https://amzn.to/2IwVWSr
My Printer: http://amzn.to/2BBYP4t
All walls are set to 1.2mm.