Someone in the facebook group asked me to upload my profile. Note that this is for the X5S-400. Not that it matters much, because even my A8 and CR10 are now doing a testprint with this profile. As long as you make sure your basic printer settings are ok.
Note that i have only used this printer for 3 days, so the only reason i'm uploading this, is because someone asked me to.
This has zero infill, but 5 walls at 0.12 layer height. The small layer height and 5 walls make up for overhangs up to 75% without infill or supports. Just like any profile, this is NOT gospel! If it fits the model, you can use this. I made this for printing figurines etc, not for parts that have to be strong. Adjust to your own liking. Seam at the back. Retraction 8mm @50mms.
Note that this is printed with the Marlin 1.1.8 firmware (see http://www.customize-3d.com/tech/flashing-tronxy-x5s-factory-control-board-usb-cable-only.html) and after PID tuning both bed and hotend. Printed on glass with hairspray.