This is a case to house a cnc v3 shield without the arduino uno; this is primarily for adding up to 4 extruders to any RAMPS style board without. This can also be used for whatever application where only the shield is present.
I've moved the screw holes so it's easily mountable. You must mount the case before screwing in the board. I've also taken the liberty to raise the screw pillars, add or move? the mounting holes, reverse the screw position as my mounting was backwards on the original model, and remove the reset switch from the case as it's not necessary for the multiextrusion use.
This is to go along with my multiextrusion project, the bowden adapter can be found here:
This is the intended use for this case. However, any use is encouraged.
I've added a reversed top as I reversed the original for the screw positioning.