For demand I made changes to my ChiChiMon to fit with a Chimera Dual Nozzle.
Fan fangs are wider and it can be mounted without work on the X-gantry of Tronxy x5s or similar.
The X-endstop must be changed: mine is at the backside of the gantry. Keep that in mind.
Nozzle will be lower than original, so best use the bed-lowering https://www.thingiverse.com/thing:2825583
Both heatblocks should jut out to the front.
1x ChiDuMo (printed)
2x M2,5 x 8mm (10 and 12mm should also fit)
1x Chimera Dual Nozzle + 30x30 Fan + stock screws
1x BL-Touch (3d-Touch) + stock screws
2x 2x 5015 blower fan
4x M3 25mm screw + nut
The BL-Touch (or 3D-Touch) should measure 1mm below the nozzle and can be set down with spacers.
Distance settings for probe measured from the left nozzle:
z -1 (measure by your own)
I can not test it. So if something should be changed, let me know. If installed, please post a "Made".
Chimera_Dual_Nozzle_Wider_Fangs.stl are a little bit wider(53mm) and bowed outside.
Hot environment! Better print in PET-G or ABS.
Supports should only needed from builtplate