Updated June 8, 2018(NS_Iris_Box_fuji6.stl)
I updated the design, since all people reported "outer ring is loose, lift up and fins are off".
I added stoppers at bottom of the outer ring(red parts in above picture), which should stop lifting of the ring. This parts are not included in original design.
- I made variations "NS_Iris_Box_fuji6_01.stl" which has 0.1mm thicker fins and "NS_Iris_Box_fuji6_02.stl" which has 0.2mm thicker fins. So if you have good printers and print it in 100% or larger size, please try them.
Added April 22, 2018(NS_Iris_Box_fuji5_8.stl)
This is a test model to know what is wrong and best settings.
New April 22, 2018(NS_Iris_Box_fuji5.stl)
This is a remix of "Preassembled Iris Box" by emmett. This may be good challenge that how you understand 3D printing.
Since original model was not so fine and I wanted to know how the parts are linked, I reconstructed it in CINEMA 4D.
width 0.34 mm, thickness 0.17 mm
Printer name: hand made, m200
Filament: 3DXTech CFR-PETG
Nozzle: 0.3mm stainless
Print width: 0.34mm
Layer height: 0.17mm
Injection ratio: lower
Retraction length: 0.75mm
Layers: top 5, bottom 4, side 3
Skirt: 5 turns, 0.5mm gap
Temprature: 260 C
Speed: 1800mm/min, 80% at outline, infill, support, 25% in small areas
Print size: 75% of original
Print time: 12 hours