This is a Complete New Version for a CR10 Fang.
Its easy to Print, because it does not Print upwards. The Fang lies with the most of its area on the bed. It got easy Support Remove too.
Bridging and Overhangs are much more better than with the OEM Fang or the Stock Fang.
You can use nearly all original Parts for this Fang. You only need 20mm Screws for mounting the Fang and the Hotend to the x Carriage (Original is 16mm)
You can use all 40x40 Extruder Fans that you want. (Also the Stock one) and you need the Stock component-fan.
Have Fun Printing!
Special Thanks are going to: Paul McMaster, who was Printing the Fang out and Tested it.
The Print was Tested with this Parameters:
3 Solid Bottom
3 Solid Top
3 Outside Shells
Supports only from Bed!!!!