A print in place bracelete, that looks as though it has no clip or other joint, when it is on your wrist.
Printed on: CR-10
Turn the model by 90° bevore slicing! the flat side is on the print bed!
Layer height: 0.2 or lower
Bed Temp.: 60°C
The first layer can be tricky, make sure your bed is leveled properly. I used some ABS slurry on masking tape. Maybe printing directly on glas may give you a shiny surface finnish, which would add to the design.
chain3.stl is shorter and the clip is not very tight, but very easy to close
chain4.stl is longer and the clip is very tight and secure, but kind of hard to close with one hand, so you might need a friend to help you putting on the bracelete